De verkoopomgeving: alle vooroorlogse auto's te koop

BTH magneto for a 4 cylinder engine. Type AG-4(6) N° ML 9682. Incomplete, both caps missing, but good coupling mounted. Turns. Suitable for spares or build-back up.

BTH magneto for a 4 cylinder engine. Type AG-4(6) N° 076367. Incomplete, both caps missing, rear coupling is there. Turns. Suitable for spares or build back up.

Magneto with sprocket for a single cylinder engine. Type A1. N° 226353 - made by S.E.V. - Paris. Most likely came off a motorcycle.

Pair of sidelights for on fenders of a 1920's American car. Could be for Buick. 7cms outer diameter. Good condition, no dents at all but will need to be repainted. Int ref: OS 49H

Large Claxon type horn made by the American Bosch Magneto Corporation of Springfield (Mass.) USA - in good condition. Chrome will polish up. 14cms outer diameter.

Older American updraught carburettor made by Kingston. Model L1, N° T 61361. Large 40mm throat. E.g. used on tractors and trucks. Good overall condition for age but cork float needs to be remade.

Lucas magneto for 4 cylinder-engine as used e.g. on Fordson E27n-tractors. In serviceable condition but bearing may have to be replaced.

Sankey type spoke wheel for a vintage car in good condition. 12 spokes, 20 inch and 6 studs. 124mm diameter centre hole and 161mm measured across the stud-holes.

Nos carburettor for Ford V8 flathead. Also used on Judson compressor.

Wire spoked wheel for pre-1925 American cars. 6 stud, for beaded edge tyres, 85mm width, overall diameter 644mm. Stud spacing 160mm. Three spokes need to be replaced. This pattern was made by several American manufactures including Hayes, Dayton and Houk for car such as Hupmobile, Buick and Marmon.