De verkoopomgeving: alle vooroorlogse auto's te koop

for sale nw painted wheel for ford A 1928-1929 21 inch

for sale nw. wheelcover for A ford 1929-1930

Original Bosch FD6A 6 volt motorcycle horn. These were used from the late 20's, through the 1930's. It works well and is very loud. The trumpet-part has a slight dent, however, this is repairable. The rest is OK, and still has most of its original paint, and the mesh and brass badge are still intact. I can post this, and I accept PayPal.

Four flute horn missing two flutes needing restoration.  This horn would restore into an excellent and most attractive horn as the sound from the two intact flutes is wonderful. Overall length 43 Cms.  Largest diameter flute is 6 Cms.  A similar but unmatched brass flute will be included in the sale. Additional photos on request.

Triple flute horn has great patina and is stamped 'Made in Germany' on the smallest flute.  Excellent sound and comes with a 10 Cms diameter rubber bulb which is in good condition.    Overall horn length is 34 Cms with the largest flute mouth diameter 5 Cms and smallest 3.5 Cms.  Bulb length is 15 Cms.  More photos on request.

for sale 2 overhaul shoks for FORD model A 1928-1932

Fully renovated Ford Flathead V8 - 1938 (21 stud)* Grinded camshaft with new bearings * Milled engine block and honed cylinders with new pistons and piston rings* New valves and liftersPlease send an e-mail for more info and pictures

Motorcycle horn, make "Cicca", Paris. Probably from the 1930s. The unit is fixed to the motorcycle fame end a cable needs to be pulled so that the rubber drive wheel engages against the motorcycle tyre.  Appears to be mechanically complete but I have not had it installed on a motorcycle so I have not been able to verify that it works...

This is an original aftermarket oil sight gauge for a Model T Ford. It replaces the two taps on the sump to check the oil level. Typically a plug was fitted where the upper tap was, and this gauge was connected to the lower tap fitting, with the lower tap than attached to this gauge. The height of the gauge meant that is was easy to see the oil ..