De verkoopomgeving: alle vooroorlogse auto's te koop

Cylinder block for Fiat 501. Not tested but looks OK.

I am commissioning some new crown wheel & pinion sets to suit Fiat 501 & 503 models. The ratio will be 4.6:1 instead of the original 5.1:1 and they will be made in the UK. The cost is likely to be between 500-600 GBP plus 20% vat per set. In order to get the best price I need to order 10 sets but I only have 5 orders so far.If you are in..

Complete large rearaxle with driveshaft off a circa 1912 SCAT. Discovered and unearthed this month in a dry part of Australia. But one end of the axle has been laying in a creek and when the area got flooded it was submerged for some time and developed rust.Crown and pinion are in position with good albeit rusty teeth.Both brake drums complete and ..

A Lancia Aprilia rear axle, complete, unrestored, buyer collects or can be Rolle onto a pallet and collected at buyers expense.

Parts for FIAT 509. Abandoned project of building MM replicas. 3 paletts of parts including engine blocks, gearboxes and some sterring and rear axle parts. Some parts are new like timing gears or chains. Some rebuild (one head). Engine blocks in avarage to poor condition. Dynamos and some other parts included. Parts located in Poland.I ha..

Hello, I am looking for a  tail lamp for a 1935 Balilla. and any F hubcaps    As of February 2018 I still need these parts. thank you

Differential Box, pin and the four pinion gears, remanufactured by the Humber Register of the highest standard and made from the best materials, brand new and never fitted, Humber Register current price over a thousand pounds!!

0-15 psi oil gauge to suit fiat, nice condition

Brass FIAT 22mm side draught carburettor. It is missing its float and the float cover, otherwise it is complete with the jets and levers and choke.can send more photos on request.PayPal accepted.

Used Lagonda high chassis light axle. Surface rust but sound.