Four complete rims in good original condition. Nice edges where the clamping rings connect. Look like the clamping rings might have been rechromed in the 1980s. Could do with a re-chrome again on the clamping ring or otherwise just paint that piece. Also included are four good rubber inner tube/spoke protectors/flaps. ( not the tubes but the pro..
Dear Automobilists,I bought the remains of a Franklin Type (Series) 10B body. Rather than fitting it to a frame of another make, I wonder if it would be possible to acquire further parts to rebuild it as an Franklin. The "frame" was made from wood, and axles were screwed undernath. So, if anyone has parts to offer in view of a rolling cha..
A nice pair of early 1920’s spade mounted Rushmore sidelamps. They have been fully restored some time ago but stored in damp conditions which has effected the nickel plating as shown in the photos. There is also a small area of bubbling on one reflector as shown in the photo. They measure 7” or 180mm in outer diameter. I accept PayPal and will p..
Original New Old Stock Atwater-Kent Unisparker K-2 6 cylinder distributor cap.
This is a very rare item. This would suit a few American cars (Saxon Six?) from 1909-1915.
This is the only one I have.
I can send more photos on request. PayPal accepted.
PAIR OF RUSHMORE 7INCHES/18 CMS BRASS HEADLAMPS These 7 inch/ 18 cms brass Rushmore Headlamps are quite a rare find for a large Brass Era automobile. CONDITION AS SHOWN IN PICTURES