De verkoopomgeving: alle vooroorlogse auto's te koop

Original 1932,33,34 Ford Stainless Steel clad trunk or rumble lid handle. It can be used in either application.If for a trunk the handle must be shortened.Includes 2 working keys.Chrome slightly worn on the barrel which is of brass.I did a light polish to remove some deep scratches on the stainless handle.Excellent condition and ready to install..

An original early oil or petrol can for a Ford car.  Front and back are both embossed with FORD script.  It is 6 inches square and 8 inches tall excluding handle and cap. In very good condition, not tested if it holds fluid.  Buyer pays shipping cost.

ENV manual gearbox casing for Invicta. Original casting with "Invicta" on side.  Crosstube bosses both undamaged. The bellhousing has cracked and been welded - but will need redoing before this can be used. Can either be repaired or new bellhousing section used to replace existing - which I have done.  This is a crisp origin..

I´m looking for a cone clutch only or with a gearbox for a vinot engine from circa 1906-09.Any cone clutch is interesting. I´m also looking for chain drive chassi and/or parts for it.

For sale a V-belt pre-war motorcycle or car, in original. Shipping worldwide at cost and PayPal accepted.4/8 inches or 2/4 inches; 12mm-13mm; 2.5 meters length = 139 euros; mostly for 74ccm to 118ccm or mostly for auxiliary bicycles; Alternators; Water pumps5/8 inches; 15mm-16mm; 2.5 meters length = 149 euros; mostly for around 200..

Complet, ancienne et très belle refabrication, Non PS  Complete and beautiful old rebuild clutch, no PC Shipping World Wilde 

for sale ,mascot for FORD A or B compl with temp. gauge

For sale a V-belt pre-war motorcycle or car, in original. Shipping worldwide at cost and PayPal accepted.4/8 inches or 2/4 inches; 12mm-13mm; 2.5 meters length = 139 euros; mostly for 74ccm to 118ccm or mostly for auxiliary bicycles; Alternators; Water pumps5/8 inches; 15mm-16mm; 2.5 meters length = 149 euros; mostly for around 200..

Here is an original, round tube, brass radiator. It has the Ford script and the Made in USA on the front as well as what looks to be an original Ford Motor Company tag on the rear of the top tank. This is an old radiator that has it share of old repairs and bruises. It looks decent and displays well. This would not be recommended for a "driver" car..

Ein Muss in jeder Hot Rod Bude als Dekoration zu verwenden, ein Original Ford Model A Kühlergrill Frontmaske mit schönem Chrom, natürlich nicht mehr zu verwenden aber durch sein Alter und der schönen Patina, habe ich als Regal umgebaut ein absoluter Hingucker. Das Holz wurde von mir geflämmt und lackiert und mit einem schönen Fotodruck versehen...