De verkoopomgeving: alle vooroorlogse auto's te koop

A pair of Rotax gauges possibly 1st WW suit aero engined car, voltmeter & ammeter in used condition. Case size is 47mm.

Vintage supercharger gauge in working orderApprox 3 inch  diameter 

Very rare original  1920's  Cambridge temp gauge to suit  a Vintage Bentley team car.This  is not  a modern copy . It is in a fully restored working condition with the good original 1920s dial still fitted. Please note -       I can only post this to a UK address.

Lovely DeWandre vacuum gauge, brass bezel would suit suit aero special.

A set of the four special, Plated, Raised Countersunk 1/4" x 3/8"" BSF sets that held the prop. shaft cover in place on 'Ulsters' and, possibly, other Austin 7 cars. These are very old stock, but in reasonable condition. I once had a large stock  and found these few in the proverbial tobacco tin ! I have a couple of sets only. As far as I know th..

A set of the four special, Plated, Raised Countersunk 1/4" x 1/2" BSF sets that held the instrument panel in place on 'Ulsters' and, possibly, other Austin 7 cars.These are very old stock, but in reasonable condition. I once had a large stock  and found these few in the proverbial tobacco tin ! I have a couple of sets only. As far..

A N.O.S. head and exhaust manifold gasket set for an Austin 7. The head gasket is of the High Compression type.There is very slight damage, just beyond the final stud hole, to one end of the exhaust gasket. This is visible in the photo. This is very old stock, so please be aware it may possible be a Copper/Asbestos composite. However, i cannot b..

Austin 7, engine front timing gear which fits on the nose of the crankshaft. These are original Austin parts. They have no '+' or '-' markings so must be considered to be for a within tolerances assembly. However, in my experience, timing gear pairs are best matched by fitting as a pair, regardless of marks and measuring the backlash unti..

A set of very old stock Austin 7 sump retaining bolts. They have the special deep head and are threaded 1/4" B.S.W. Please also note that there are probably cadmium plated as original and should be handled with care as I understand that cadmium may be harmful if ingested! There are 14 bolts in the set.As the item is ..