De verkoopomgeving: alle vooroorlogse auto's te koop

Overzicht van gerelateerde advertenties Steering box for Bugatti Type 57

  • Bugatti chair

    Bugatti chair

    We made 6 pairs of solid Oak replica Bugatti chairs for an engineering exercise. Beautiful crafted by a furniture designer / manufacturer, Charlie Caffyn Furniture. We have two of these left and can be bought as a pair or on there own
  • Brescia windscreen and Wings

    Brescia windscreen and Wings

    I have a pair of rear cycle wings and a wind screen and pillars removed from a Brescia we restored 35yrs ago.  They would suit any small vintage car really with 19" wheels and a 400 -500 profile tyre The screen pillars are original Brescia fitment and the screen measures 84cm across and 28cm tall in the centre ..
  • Brescia Cast ali Steering wheel

    Brescia Cast ali Steering wheel

    I have made a batch of 5 cast Ali steering wheels. They have been fully heat treated, machines, fettered and wooded. As used on the early cars and with an additional mounting for the Advance and retard and hand throttle.  The overall diameter is 16" or 41cm. There is 1" of Dishing and the grip is 35mm in width and 23mm deep. The centre is..
  • Bugatti type 43/55 front dynamo housing

    Bugatti type 43/55 front dynamo housing

    Front dynamo housing, original piece fully machined but with missing section (as photographed)
  • Type 30 steering box drop arm

    Type 30 steering box drop arm

    This is a second hand original plated part, partially worn. 220mm from hole centre to ball center.
  • T35,T37, T51 Rear Axle differential

    T35,T37, T51 Rear Axle differential

    This is one of the best preserved original rear axle differentials I have seen. All parts are original and parts from MINOR surface rust and old oil TOTALLY usable for a road or race car restoration project where original parts are desired over replica. As a whole unit the two halves with half shafts rotated beautiful and were set up with correct t..
  • 4 Half shafts with bevel gears

    4 Half shafts with bevel gears

    4 Original Half shafts, 3 with Bevel gears fitted
  • T37 Dashboard

    T37 Dashboard

    This is a pair of ORIGINAL standard T37 dashboard panels as removed from a car restored over 45yrs ago. They have been lurking in the back of my container for 5yrs after out workshop move. They could be restored to fit onto a pair of new steel supports and Ali angles which I also have. I have the Bosch switch and all the instruments to co..
  • T43a Dash board fascia

    T43a Dash board fascia

    This is a dashboard fascia for a T43a, it was over laid ontop of the wooden panel to a car restored many years at our workshop. We have no record of which car but this should be of use to someone building up a T43a
  • Original T57 Dashboard

    Original T57 Dashboard

    An original Series 1 wooden dash panel with stunning Silver Bugatti Owners Club awards and a paper note. Removed from the car in the 1970's this had also been in a container for the last 5yrs after a workshop move. It would not take much to bring this back to life on and replace a non period dashboard  Another ..

Uitgelicht